Replacing a Schneider Relay Module

To change the Relay Module, follow the below listed steps.

1. Switch off the equipment and unplug the machine and ensure there is no power.
2. Open the control panel on the side by removing the lock.
3. Locate the Relay Module that is not working.
4. Remove the cables from the Relay Module both from the input and output side by using a tester and rotating the screw in the module where the wires are inserted. Please note the location of the cables.
5. Replace the faulty relay with the corresponding new relay in the exact same location.
6. Put back the input and output wires which were removed in point 4 using a tester. Please ensure the wires are matching the same colour coding.
7. Close the electrical panel cover and lock the same.
8. Plug the equipment back into the socket and switch it on.

Click here to buy relays